 |
You are working on replacing your 1994 Mazda water pump you are having a hard time to remove the crank pulley you need help?In: Mazda MX-6 |
[Edit] |
[Edit] 
To answer the above question do the following:
Go to the starter. open the starter and jam the wheel with the assistance of someone or use a flat iron bar or strong flat screwdriver. This will prevent the crank pully from turning when trying to remove the nut.
First answer by LoganGovender. Last edit by LoganGovender. Contributor trust: 23 [recommend contributor]. Question popularity: 35 [recommend question]
|
Research your answer: |
Can you answer other
questions about Mazda MX-6 cars?
- How much should a complete tune up cost on a 1997 mazda mx-6?
- Where is the fuel filter on a 93 Mazda mx 6?
- MX6 jerks and stalls while driving normally cold or humid mornings no one can fix it has gotten worse this year Spent thousands since 2000 Any ideas?
- Which area of the engine block has a frost plug that you can replace with a block heater on an 2004 Mazda 6 2.3 Liter?
Answers.com > Wiki Answers > Categories > Cars and Vehicles > Asian Cars > Mazda > Mazda MX-6 > You are working on replacing your 1994 Mazda water pump you are having a hard time to remove the crank pulley you need help?
Our contributors said this page should be displayed for the questions below. (Where do these come from ) |
| If any of these are not a genuine rephrasing of the question, please help out and edit these alternates. |
How do you remove water pump on 1994 mazda 121? How do you remove the water pump on 1994 mazda b3000? Do you remove the crankshaft pulley to remove the water pump in a 1994 mazda 626? How do you remove the crankshaft pulley when replacing the water pump on a 1984 Mazda B2000 truck?
