![]() |
Where is the thermostat located on a 1996 Chrysler Sebring Convertible JXI 2.5L 6 cylinder?In: Chrysler Sebring [Recategorize] |
[Edit] |
[Edit]
Answer
The engine thermostat is located in a thermostat housing, located below the throttle body.
REMOVAL
- Drain cooling system to the thermostat level or below.
- Remove inlet hose and coolant elbow from thermostat housing.
- Remove thermostat assembly, and clean sealing surfaces.
INSTALLATION
- Install thermostat into the recess in the thermostat housing.
- Install inlet elbow and tighten the bolts to 12 Nm (133 inch lbs ) .
- Fill cooling system.
standing on the drivers side, looking at the engine, it's under the radiator cap housing. there are (if i remember correctly) three bolts (10MM?) not very easy to get your hand/tools down in there. it's not that bad to replace, just tedious.
First answer by ID0000000000. Last edit by Trborders. Contributor trust: 9 [recommend contributor]. Question popularity: 83 [recommend question]





