Home
 |
What is the procedure for removing the a 5-speed manual transmission on a 1998 Dodge Ram 1500 4WD with a 5.2L engine?In: Dodge [Edit categories] |
[Edit] |
Answer
To start, remove the drive shaft from the rear end.( there should be four bolts holding it on). Remove the shifter completely. Next, remove all of the bolts from the bell housing that fasten the tranny to the rear of the engine.(you will need to remove the starter and oil filter to complete this). Then, place a jackstand underneath the transmission and remove the crossmember with the transmission mount. In most cases, the collector pipe for the exhaust will need to be unbolted from the headers. Before removing the tranny, make sure all wires and clutch connections are removed. At this point, you should be able to drop your transmission. - good luck, and be prepared to spend a few hours doing this.
First answer by ID0000000000. Last edit by ID0404497204. Question popularity: 67 [recommend question]
|
Research your answer: |
- Where would you look to find a diagram of a steering column for a 2006 dodge stratus?
- Do you have a Serpentine belt diagram for 2005 dodge ram 1500 5.7L hemi?
- What size speakers fit in the doors of 2006 dodge ram?
- How much oil does a 1997 dodge dakota take after changing with a 5.2 litre and changing the filter?
Answers.com > Wiki Answers > Categories > Cars and Vehicles > American Cars > Dodge > What is the procedure for removing the a 5-speed manual transmission on a 1998 Dodge Ram 1500 4WD with a 5.2L engine?
Our contributors said this page should be displayed for the questions below. (Where do these come from ) |
| If any of these are not a genuine rephrasing of the question, please help out and edit these alternates. |
