![]() |
How do you replace a starter on a 1995 Isuzu Rodeo 2WD V6?In: Isuzu Rodeo [Recategorize] |
[Edit] |
Answer
Take the neg battery cable off. Then the wires off of the starter then the bolts that hold it on. Then sometimes you have to remove th exhaust manifold to get it out.
Answer
you dont have to remove manifold just the 3 bolts holding the pipe to the manifold then cut the 2 bolts off the flanged conn. next to the flex loint ( this is from a 99 4x4 hope its the same ) manifold pipe bolts are self locking and damn tight you have to glow (torches) them always remember fire bad should be done by someone experienced. cut the rear weld nuts off the flange. if you complete this and dont burn the truck up you need to check the flange at manifold make sure it good and clean joining surfaces at rear flange buy new nuts for manifold and new nuts and washers for rear flange i reused old gaskets they were fine
Answer
Go how to change a starter on a 92 isuzu rodeo in this forum for a more detailed explanation of this process !
First answer by ID0000000000. Last edit by ID3451679945. Question popularity: 56 [recommend question]





