![]() |
How do you replace a fog light bulb on a 2000 Infiniti I30?In: Infiniti I30 [Recategorize] |
[Edit] |
Answer
If you look under the bumper in the area of the fog lamp, you will
see a plastic cover preventing access. There is about a 2 " hole in this cover.
If you look into the hole you will see a screw head. This is the fog lamp assembly screw. You must remove it to remove the assembly to get at the bulb.
However, you really need to remove a few screws and clips to get under this access cover. This is the only way you can remove the bulb wires from the back of the assembly as the assembly slides forward out of the bumber.
After you get under this plastic cover, remove the side bulb by twisting slightly counter clockwise.
Remove the Fog lamp wire by twisting that connector as well.
There will be two wires still connected to the back of the fog lamp.
remove these carefully.
There is a push clip on the side of fog lamp assembly toward the engine.
Push this with your finger or the head of a screwdriver. Push on the back of the assembly and it should slide out.
Once out, you should be able to figure out how to remove and replace the bulb and then re-install.
There is also a PDF repair manual on www.pdftown.com that you can download for free. Once downloaded, you can open each chapter as individual PDFs. The password for each doc is "pdftown.com"
First answer by ID0410219726. Last edit by ID0410219726. Question popularity: 17 [recommend question]





