How do you remove the valves in a 2000 model Daewoo Nubira?

dermining the differences between valves

Hi there champ, i am just surfing myself on this site but i can answear this question for you.

this all depends on how the valves sit inside the head cylinder, you have two different types of valves which is, 1} insinked valves 2} standard valves. to determine the differences between the two, the insinked valves are valves that have been sinked inside and into the engine head cylinder, the steps down below follow for non insinked valves inside the head cylinder. for normal valves you can buy a tool from a spare part shop to take the standard valves out but if you have insinked you need a machine to take them out but if you go like i did to a head specialist they could do it for you and put them back in because the have a hydralic/air compressor that does the job. ok!

1.step= take the rocker cover off. 2.step= take the cam shaft off. (TAKE NOTE PLEASE : the timing belt will have to come of aswell) 3.step= (if over head cam) remove caps from the top of valves. 4.step= remove the head from engine. 5.step= remove the valves with the valve remover tool purchase from any spare part shop. as mentioned before if they are INSINKED you will have to compress them out.

that should answear your question to the finest detail that i can put it for you.

i hope this helps!

First answer by ID1021682118. Last edit by ID1021682118. Question popularity: 61 [recommend question]